Straw briquette is a new type of biomass renewable resource, which is clean, environment-friendly and has a wide range of applications, and can replace coal as fuel. It can also be used for domestic heating, hot water boilers, industrial boilers, biomass power plants, etc. It can also be used as livestock feed for livestock.

Straw briquetting machine solves the problem of waste and littering of rural straw resources, and it is a kind of equipment which is beneficial to agriculture, environment and society under the increasingly severe environmental problems.

In the process of using straw briquetting machine, it is very important to use straw briquetting machine efficiently, and we need to pay attention to some key points.

1.Please read the machine instructions carefully before use, and operate the machine in strict accordance with the instructions and specifications.

2.Make a daily work log to record the abnormal phenomena in production. Clean the machine in time after work every day.

3.Check the straw briquetting machine regularly, especially whether the screws at the connecting parts of the transmission parts are loose, and tighten them in time; check the wear of vulnerable parts, and replace them in time if they are seriously worn.

4. Do a good job of machine lubrication. To fill the oil hole of the rolling wheel once a day (at the top of the eccentric shaft) and once a week in the vertical shaft seat, the butter used is high-temperature resistant lithium-based grease.

5. Control the water content of raw materials. The water content of corn stalks, wheat stalks and rice straw can be molded between 10% and 30%, and the water content of peanut shells and rice hulls is between 12% and 14%.

6. Do not idle without materials in the hopper. If the raw material humidity is too high, the machine should be shut down in time, the wet material in the hopper should be cleaned, and then the qualified raw materials can be added for normal production.

7. If the machine has abnormal noise, stop and check immediately, it is forbidden to remove the hopper boot, in case of pressure roller cuts.

8. The density of the briquette product can be adjusted by adjusting the gap between the pressing wheel and the die. The gap between 1.5~2.5mm and 2.5 mm is the working state of the main engine. Check the gap and wear between the rolling wheel and the mold of the forming machine in time, and adjust, repair or replace it in time.

Doing the above precautions in the daily use of straw briquetting machine equipment can not only prolong the service life of the equipment, but also improve the production capacity of the equipment, as well as save the maintenance cost and use the straw briquetting machine more efficiently.