How to prolong the service life of the mould of straw briquetting machine
Mould is one of the key parts of straw briquetting machine, and it is also one of the parts that are easy to wear. If the use of straw briquetting machine is not standardized, it will easily cause the abrasion of abrasive tools, which will not only affect the normal production of machinery, but also greatly reduce the production efficiency and affect the production efficiency. In addition, it is not a small expense to change the mold frequently. When the straw briquetting machine works, how can we extend the service life of abrasive tools?
How to prolong the service life of the mould of straw briquetting machine, there are mainly the following points:
First, clean up the oil regularly.
Every day after the end of production, oil should be used to replace the straw residue left in the mold hole. I would like to remind you that if the mold is not used for more than one month, it is recommended to take out the oil in the mold, so the oil will gradually harden during long-term storage, which will make it difficult to remove it when it is used next time, seriously affecting the subsequent use of the mold.
Second, the mould needs to be cleaned after long-term use.
If you don’t use the mould and the press wheel for a long time, it is recommended to remove the mold and clean it before storing it. On the one hand, it prevents particles from hardening and being difficult to remove due to long-term storage, and on the other hand, because sawdust has water absorption, if the residue on the surface is not removed, it may accelerate the corrosion of the mould surface.
Three, the mould should be stored in a dry and ventilated place.
The mould of straw briquetting machine is mostly made of alloy steel. If it is kept in a humid place for a long time, the surface of the mould may be damaged by air corrosion, thus greatly reducing its service life.
Fourth, the handling process should be careful.
The mould of straw briquetting machine is a high-precision accessory, and the mould holes are carefully processed according to the compression ratio of the mould. If the structure of the inner wall of the mould hole is damaged in the process of handling, the forming rate may be low and the service life may be short.
Fifth, filling with oil.
After the daily production and processing, it is necessary to use oil to grind for a period of time to ensure that all the oil is left in the mould hole, which is of great benefit to the next day’s work and is also conducive to the long-term use of the mould. Oil can be made by mixing waste engine oil and straw, which can be made at one time and recycled.
The above are the main points to prolong the service life of the mould of the briquette machine. When using the straw briquetting machine, the machine must be operated in strict accordance with the use specifications of the machine, and some precautions for die protection must be strictly observed. Only in this way can the normal use of the straw briquetting machine be protected to the maximum extent, the service life of the mould can be prolonged, the expenses can be saved, and greater value can be created for the enterprise.