How to reduce the wear of wood crusher machine?
It is inevitable that wood crusher machine will wear after working for a long time, so are there any ways to help us reduce the wear of the machine in daily use? The answer is yes.
To reduce the wear of wood crusher machine, the following points need to be done:
First of all, do a good job of regular cleaning.
Clean up the accumulated material residues in wood crusher, and clean up the waste oil in the bearing seat quickly, and then add new lubricating oil to ensure that the bearing is in a good state for production. If the bearing is produced without cleaning up the oil shortage, it is very easy to cause surface wear or damage, so we usually need to clean and change the oil in the bearing seat every 300 hours.
Secondly, we also need to check the tightness of the belt regularly.
Because the power generated by the motor or diesel engine is transmitted through the belt to drive the whole wood crusher to carry out production work, once the belt is too loose, the power cannot be transmitted smoothly, which will affect the normal production work in wood crusher. If it is too tight, it will increase friction and lead to failures and problems, so we need to check whether the belt tightness is appropriate and adjust or replace it regularly.
Thirdly, clean the bearings regularly and inject lubricating oil.
There are bearings in wood crusher, and the bearings are prone to wear when they are unclean and lack of oil. Therefore, in order to reduce the loss of bearings, when wood crusher’s working time reaches a certain length, it is necessary to take out the bearings and wash them inside and outside very carefully, and then inject new lubricating oil to ensure that the inside of the bearings is clean.
In addition to the above three factors, the hardness and humidity of wood will also affect the wear degree of wood crusher machine.
For hard wood, such as mahogany, Chinese fir, etc., the hardness is large, and the wear of the blade will be relatively serious during the crushing process. Wood crusher can crush wet and dry wood, but the humidity of wet wood should be within a certain range. When crushing materials with high humidity and viscosity, the blade head and hammer are easy to stick sticky substances, which increases the friction between the blade and wood, thus affecting the working efficiency of the machine and increasing the wear of the blade and hammer.
The wear of wood crusher machine is inevitable. In order to improve the working efficiency and prolong the service life of the equipment, we should pay attention to the maintenance of the machine. If you can do a good job in the maintenance of the wood crusher, you can greatly reduce the wear of the machine caused by improper maintenance, prolong the service life of the machine and create greater benefits.