Matters needing attention in operation of wood crusher
A lot of wood waste will inevitably be produced in people’s production and life, such as the pruning of landscaping plants, the processing and production of wooden furniture, etc, which will correspondingly produce some scraps, waste wood, branches, trunks, bamboos, etc, the wood crusher machine will crush and process these wastes and then recycle them. These waste raw materials are crushed, dried, briquetted, carbonized and so on, and finally made into biomass carbon, which is used in all walks of life, and has both economic value and environmental protection value.
When using wood crusher machine, there are some precautions:
1.The equipment shall be installed on the horizontal concrete ground, and the wood crusher machine shall be fixed with ground bolts or cement.
2.After the installation of wood crusher machine, carefully check whether it is installed in place, and check whether the installation is firm enough. Whether the motor shaft is parallel to the crusher shaft, and check whether the tightness of the drive belt is appropriate.
3. Before starting the wood crusher machine, turn the rotor by hand, check whether the operation is flexible and normal, whether there is any collision, whether the rotation direction of the rotor is correct, and whether the lubrication of the motor and pulverizer is in good condition.
4.The wood crusher machine should idle for 2 to 3 minutes after start-up, and then start feeding if there is no any abnormal phenomenon.
5.The feeding of wood crusher machine should be uniform. In case of noise, excessive temperature of bearing and body or outward spraying, stop the machine immediately to check and troubleshoot.
6. Metal objects, stones and other hard objects are strictly prohibited from entering the wood crusher. If there is any abnormal sound in the operation, the equipment should be stopped immediately and inspect the machine.
7.When feeding, the staff should stand on the side of the crusher to prevent being injured by the bounced debris. When crushing long material, do not hold hands too tightly to prevent them from being brought in. No gloves, wear tight clothes with tight sleeves, long hair should be tied into safety helmet. During work, it is strictly forbidden to put your arm into the entrance of the safety guard and inside the protective cover, and it is not allowed to remove the protective devices of various parts at will.
8. In use, it is forbidden to open the casing or protective device, and it is forbidden to overhaul or troubleshoot the machine when it is running.
9.Stops feeding before stopping the wood crusher machine. After the materials inside are discharged completely, cut off the power supply and stop the machine. Cleaning and maintenance shall be carried out after shutdown.
10. After 300 hours of operation, the bearing must be cleaned and the oil replaced; When oil is loaded, it is better to fill 1/3 of the bearing seat gap, and no more than 1/2. When the machine stops for a long time, the drive belt should be removed.
11. The workplace should be spacious and equipped with fire protection devices, and it is not allowed to clean up the job site when it is started.
Only when the preparatory work is done, the wood crusher can be used more smoothly, and the safety of wood crusher can be guaranteed, and the efficiency of wood crusher machine can be improved.