Straw briquetting machine needs to be well maintained
Straw briquetting machine is a professional equipment for briquetting straw. The processed straw briquetting can be used not only as fuel, but also as livestock feed. The traditional straw treatment method is to burn straw directly, which is not only a huge waste of resources, but also brings great environmental pollution problems, so the emergence and use of straw briquetting machine is in line with the needs of social development. The straw briquetting machine needs to be well maintained:
1. The equipment of straw briquetting machine should be cleaned after daily work from the beginning of production, and the abnormal phenomena in production should be recorded.
2. Check the screws: regularly check whether the screws at the connection parts of the motor and transmission parts of the straw briquetting machine are loose, so as to tighten them in time, and carefully observe the wear of the wearing parts.
3. Lubricate the shaft oil; In order to add oil to the oil hole of the rolling wheel once a day (at the top of the eccentric shaft) and once a week to the vertical shaft seat, the butter used is high-temperature resistant lithium-based grease.
4. Density adjustment: check the gap and wear between the roller wheel and the mold of the molding machine in time, and adjust, repair or replace it in time. The density of the finished product can be adjusted by adjusting the gap between the press wheel and the mold, and the gap is 1.5~2.5mm, which is the best working state of the main machine.
When the gap between the mold and the pinch roller exceeds 5mm, it will seriously affect the output of the equipment and the phenomenon of swallowing machine will occur. The method of adjusting the gap is as follows: loosen the round nut with a hook wrench, remove the connecting plate of the pressure wheel, loosen the locking screw for clamping the eccentric shaft in the scraper with an internal hexagonal wrench, and then rotate the flat shaft at the head of the eccentric shaft with a wrench to make the eccentric part of the eccentric shaft rotate outward, so as to adjust the gap between the pressure wheel and the die. Adjust the other pressure wheel in the same way (the gap between the two wheels and the upper and lower gaps of the I-shaped die mouth and the height of the two rims are the same). After the gap is adjusted in place, tighten the locking screw, then reset the connecting plate and lock the round nut.
Standardized maintenance of straw briquetting machine can not only ensure the normal production, but also prolong the service life of the machine, so we must keep it in mind.