Why the straw briquetting machine stops for no reason?
Straw briquetting machine sometimes stops for no reason. This frequent strike phenomenon will greatly affect the production progress. The preliminary judgment of the reason is that there is material blockage. Of course, there will be other reasons. Let’s analyze it with me.
During the use of straw briquetting machine, some producers will blindly increase the feeding speed of the feeder to add more raw materials without looking at the instrument data of the control cabinet in order to catch up with the output. In this way, the bearing capacity of the machine is exceeded, and the machine cannot press out the incoming raw materials in time, which will cause the blockage of raw materials in the compression chamber. Workers must clean the compression chamber of the double-roll crusher before continuing production. Therefore, raw materials must be added evenly in the production process, so as not to stop work because of the blockage of the compression chamber.
The straw briquetting machine will sometimes stop suddenly during its use. If the reason cannot be found out and repaired in time, the machine will cause great damage, so it can only stop working, which will make the enterprise suffer great economic losses. Where is the reason for the shutdown of compound fertilizer granulator? Now let Henan state-owned professionals analyze it for you and make a solution.
The circular mould straw briquetting machine relies on the transmission belt to transmit power, so if the belt tightness is improper, it will cause the belt to transmit power abnormally and stop working. If the belt is too loose, it will be unable to work normally because of insufficient transmission power; If it is too tight, it will make the belt wear excessively and break easily, which will also affect the work. So always check the belt tightness to see if it is suitable.
During the operation of the straw briquetting machine, the excessive difference in dry and humidity of the added materials will also cause the machine to stop due to the delay in discharging. During normal production, a part of high-humidity materials suddenly enter the added materials. Because of the low friction of the high-humidity materials, the normal extrusion force cannot be generated by the roller, which leads to temporary non-discharging. If the operator fails to find out in time to stop feeding at this time, it will cause the compression chamber to be blocked due to excessive storage, and the workers must clean the compression chamber before continuing production. Therefore, in the production process, it is necessary to ensure that the moisture content of raw materials fluctuates within the normal range, so that it will not stop because of the blockage of the compression chamber.